TP-Link T1600G-18TS T1600G-18TSUN V2 CLI Reference Guide Guide - Page 367

Switch(config)# no monitor session 1 destination interface gigabitEthernet 1/0/2 Delete the monitor session 1: Switch(config)# no monitor session 1 39.2 monitor session source Description The monitor session source command is used to configure the monitored interface. To delete the corresponding monitored interface, please use no monitor session source command. Syntax monitor session session_num source { cpu cpu_number | interface gigabitEthernet port-list | interface port-channel port-channel-id } mode no monitor session session_num source { cpu cpu_number | interface gigabitEthernet port-list | interface port-channel port-channel-id } mode Parameter session_num -- The monitor session number. It can only be specified as 1. cpu_number -- The CPU number. It can only be specified as 1. port-list -- List of the Ethernet port number. It is multi-optional. lag-list -- List of LAG interfaces. It is multi-optional. mode -- The monitor mode. There are three options: rx, tx and both. Rx (ingress monitoring mode), means the incoming packets received by the monitored interface will be copied to the monitoring port. Tx (egress monitoring mode), indicates the outgoing packets sent by the monitored interface will be copied to the monitoring port. Both (ingress and egress monitoring), presents the incoming packets received and the outgoing packets sent by the monitored interface will both be copied to the monitoring port. Command Mode Global Configuration Mode Privilege Requirement Only Admin and Operator level users have access to these commands. 346