TP-Link T1600G-18TS T1600G-18TSUN V2 CLI Reference Guide Guide - Page 290

29.3 storm-control exceed Description The storm-control exceed command is used to configure the action that the switch will perform when the storm exceeds the defined limit on an interface. Syntax storm-control exceed { drop | shutdown } [ revocer-time time ] Parameter drop -- Set the Action as Drop. The port will drop the subsequent packets when the traffic exceeds the limit. shutdown -- Set the Action as Shutdown. The port will be shutdown when the traffic exceeds the limit. time --Specify the recover time for the port. It takes effect only when the action is set as shutdown. The valid values are from 0 to 3600 and the default value is 0. When the port is shutdown, it can recover to its normal state after the recover time passed. If the recover time is specified as 0, which means the port will not recover to its normal state automatically and you can recover the port manually using storm-control recover command. Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet / interface port-channel / interface range port-channel) Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. Example Configure the action as drop on port 1/0/5: Switch(config)# interface gigabitEthernet 1/0/5 Switch(config-if)# storm-control exceed drop 29.4 storm-control recover Description The storm-control recover command is used to recover the port manually after the port is shutdown because of the storm. When the recover time is specified as 0, the port will not recover to its normal state automatically. In this condition, you need to use this command to recover the port manually. 269