TP-Link T1600G-18TS T1600G-18TSUN V2 CLI Reference Guide Guide - Page 378

destination-ip-mask: Enter the source IP address mask. The mask is required if the source IPv6 address is entered. Enter the mask in complete format (for example, ffff:ffff:0000:ffff). The mask specifies which bits in the source IPv6 address to match the rule. source-port-number -- Enter the TCP/UDP source port if TCP/UDP protocol is selected. destination-port-number -- Enter the TCP/UDP destination port if TCP/UDP protocol is selected. time-range-name -- The name of the time-range. The default is No Limit. Command Mode Global Configuration Mode Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. User Guidelines Before binding an IPv6 ACL to a VLAN or interface, you should configure the SDM template as "enterpriseV6" and save your configurations. Example Create IPv6 ACL 1600 and configure Rule 1 to deny packets with source IPv6 address CDCD:910A:2222:5498:8475:1111:3900:2020: Switch(config)# access-list create 1600 Switch(config)# access-list ipv6 1600 rule 1 deny logging disable sip CDCD:910A:2222:5498:8475:1111:3900:2020 sip-mask ffff:ffff:ffff:ffff 40.7 access-list action Description The access-list action command is used to specify a rule to be configured with policies and enter Action Configuration mode. To delete the corresponding policies, please use no access-list action command. Syntax access-list action acl-id-or-name rule rule-id no access-list action acl-id-or-name rule rule-id Parameter acl-id-or-name -- Enter the ID or name of the ACL. 357