TP-Link T1600G-18TS T1600G-18TSUN V2 CLI Reference Guide Guide - Page 368

User Guidelines 1. The monitoring port is corresponding to current interface configuration mode. 2. Monitored ports number is not limited, but it can't be the monitoring port at the same time. 3. Whether the monitoring port and monitored ports are in the same VLAN or not is not demanded strictly. 4. The monitoring port and monitored ports cannot be link-aggregation member. Example Create monitor session 1, then configure port 4, 5, 7 as monitored port and enable ingress monitoring: Switch(config)# monitor session 1 source interface gigabitEthernet 1/0/4-5,1/0/7 rx Delete port 4 in monitor session 1 and its configuration: Switch(config)# no monitor session 1 source interface gigabitEthernet 1/0/4 rx 39.3 show monitor session Description The show monitor session command is used to display the configuration of port monitoring. Syntax show monitor session [session_num] Parameter session_num -- The monitor session number, can only be specified as 1. It is optional. Command Mode Privileged EXEC Mode and Any Configuration Mode Privilege Requirement None. Example Display the monitoring configuration of monitor session 1: 347