Acer AB460 F1 User Manual - Page 289
Command Line, Hyperterminal or Term Term.
![]() |
View all Acer AB460 F1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 289 highlights
269 Address Default Setting Default IP Address 192.168.100.102 Default Acer Address 192.168.100.1 Default Subnet Mask 255.255.255.0 Note: If two GbE switches are installed in a AB7000 system, you will have to change the IP address of one from the default so that both switches have unique addresses. Command Line Configuring the 1/10G Ethernet switch can be done using a command line via telnet or by using the serial console interface. Accessing CLI through Telnet: To access command line via telnet, follow the below steps. 1. Connect a PC to a network that is accessible to the switch. For example, connect a PC to any of the front panel ports of the switch and make sure the PC has an IP address on the same subnet as the switch management IP. 2. In the PC, start a telnet client session with the switch management IP (default IP is 192.168.100.102). This brings up the switch's command line interface for user login. 3. Enter username and password to login to the switch. 4. To view the switch configurations use show commands and to configure the switch type config term to get access to the configuration commands. For help type ? or help. Accessing CLI through a Serial Console To access command line via a serial console, follow the below steps. 1. Connect a PC serial port to the switch console port. 2. In the PC, open any seral port access applications, such as Hyperterminal or Term Term.
![](/manual_guide/products/acer-computers-ab460-f1-user-manual-fb04b8f/289.png)