Acer AB460 F1 User Manual - Page 578

558 5 Acer Smart Blade Manager ID: Shows the status of the ID LED. Check Enable to enable the ID. Once enabled, the ID LED on the blade panel will flash. System Fault: Indicates the system fault status. BMC: Shows BMC status. If a BMC module is installed, the BMC IP address will appear here. Use Update to update the BMC IP. Click to reload the BMC IP. If BMC is not installed not installed appears and the buttons are disabled. Watt: The estimated power consumption (wattage) of the blade. It is a static value supplied by BIOS. Power Control Power On: Click to power on the blade. Reset: Click to reset the blade. Graceful Shutdown: Click to perform a graceful shutdown on the blade. Power Down: Click to power down the blade. Sensors This section displays the motherboard identifier for easy reference. The sensor table shows the CPU(s), system temperature and voltages of the selected blade system. The table headers indicate the status, sensor name, reading and the low and high limits. If the status of a sensor is normal, the reading will be in blue and the sensor will have an OK symbol. If a sensor status is out of range, the reading will be red and the sensor will have a fail symbol. If the sensor is not present the reading will be N/A.