Acer AB460 F1 User Manual - Page 83

63 Item 4 5 6 7 8 9 10 11 12 Name Description Default Policy When IP ACCESS CONTROL is enabled, you can select either Accept or Drop from this pull-down menu to either allow or deny access according to pre-defined rules. NOTE: If set to DROP and you do not have a set of rules that will accept the Internet connection, then an Internet connection over the LAN is impossible. In this case, you need to change your security settings via modem or by disabling the IP ACCESS CONTROL. Rule# Enter a rule number in the box for a command (or commands) that will be used by the IP ACCESS CONTROL. IP/Mask Enter the IP address or an IP address range for which the command(s) will be applied. Policy This item instructs the IPMI what to do with the matching packages. NOTE: The sequence or the order of the rules is important; rules are checked in ascending order until one matches. All rules below the matching one will be ignored. The default policy applies if no matching rules are found. Append Select this option to add IP Address/Mask, rules or commands to the existing ones. Insert Select this option to insert IP Address/Mask, rules or commands to the existing ones. Replace Select this option to replace an old IP Address/Mask, rule or command with a new one. Delete Select this option to delete (a part of) an existing IP Address/Mask, rule or command. Max. Number of Failed Logins Enter the maximum number of failed attempts or failed logins allowed for a user. If the number of failed logins or attempts exceeds this maximum number allowed, the user will be blocked from the system. NOTE: If this box is left empty, the user is allowed to try to login to the server indefinitely. For network security, this is not recommended.