Acer AB460 F1 User Manual - Page 40
Module Installation, USB Switch
View all Acer AB460 F1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
20 2 Chassis Enclosure Software Setting Default Subnet Mask Reset to 255.255.255.0 To reset these values, press and hold the Reset button for five seconds. USB Switch Figure 2-10. USB Switch on Rear of CMM The USB ports on the CMM can function in either 2.0 or 1.1 mode (the default is 1.1). A switch located on the PCB at the back of the CMM module is used to change the USB mode (see Figure 2-10). To access the switch, you need to remove the CMM from the enclosure. Pull the CMM out and locate the switch near the large gray connector. The settings are silk screened on the PCB. After setting the switch, insert the CMM module back into its bay. Module Installation Make sure the cover to the module has been installed before proceeding. Installing the Module: 1. Remove the dummy cover from the bay you want to place the module in. 2. Place the module's release handle in the open position. 3. Slide the module into the module bay until it stops. 4. Push the release handle to the closed position. 5. After the module has been installed and the handle locked, it will turn on and a POST test will run to verify it is working properly.