Brother International HL 2700CN Users Manual - English - Page 121
K kit, Replacing the transfer belt cleaner - transfer roller
UPC - 840356824994
View all Brother International HL 2700CN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
120K kit When you see the following message on the LCD, you must replace the items in the 120K kit, which are the transfer belt cleaner, transfer roller, paper pick-up roller, separator pad and transfer belt. ■ We recommend that you call your service provider when you see the following message on the LCD panel: REPLACE 120K KIT READY ■ It is also recommended that your dealer or Brother Customer Service replace the paper pick-up roller, separator pad and transfer belt. ■ When you replace the transfer belt cleaner and transfer roller, please follow the instructions. See Replacing the transfer belt cleaner on page 5-16 and Replacing the transfer roller on page 5-18. Replacement of only the transfer belt cleaner and the transfer roller is not a full 120K service and the counter should not be reset until these additional parts are replaced. Replacing the transfer belt cleaner Both ends of the transfer belt cleaner roller consist of metal bearings that connect the bias element to the power supply. These must be connected properly when you install the transfer belt cleaner. Be sure to check how to connect them properly by looking at the old transfer belt cleaner before you begin replacement. 1) Turn off the printer power switch. 2) Open the top cover of the printer. Figure 5-20 5 - 16 ROUTINE MAINTENANCE