Canon VB-S800D Mark II Network Camera Operation Guide - Page 226

Troubleshooting Before contacting the dealer from whom you purchased the product or Canon Customer Service Center, check the following items. If a log message is displayed, check the details of the message and the corresponding countermeasures in the log message list. Note • For information on troubleshooting for the Camera Management Tool, Recorded Video Utility, and Mobile Camera Viewer, please refer to each individual manual. • A problem caused by the security software may occur. Configure to exclude the camera, or the software where the problem occurred, in your security software. Problem The camera does not launch. Cannot connect to the camera. The Camera Viewer will not launch. Cannot use some functions of the Camera Viewer. Countermeasures • If you are using a PoE hub, check if the LAN cable is connected correctly. • If you are using an AC adapter (sold separately), check if the AC adapter is connected correctly. HM4x H730 • Turn the camera off and on again (please refer to "Installation Guide"). • Check if the LAN cable is connected correctly. • Check if the network to which the camera is connected is set up correctly. In particular, check if the IP address, subnet mask and default gateway address are set within the ranges supported by the applicable network. • If you have changed the IP address, the new address will not become effective until the camera is rebooted. • Check if the correct URI (camera IP address) is entered in your web browser. • Check whether the connection is from a computer whose access is blocked in [Security] > [Host Access Restrictions] (P. 185) on the Setting Page. • Ask your system administrator whether the authentication method set in [Security] > [802.1X] (P. 190) on the Setting Page and the combination of [User Name], [Password] and certificates match the rules of the network to connect to. • Configure to exclude the camera, or the software where the problem occurred, in your security software. • If the message "Your web browser is not supported." is displayed, use Internet Explorer 9 or greater, or a version of Chrome that is guaranteed to operate. • If the message "JavaScript is not available or disabled on your web browser." is displayed, click [Network and Internet] > [Internet Options] > [Security] > [Custom level] in [Control Panel], and set [Active scripting] to [Enable]. • To enable authorized users and guest users to use the Camera Viewer, specify the following settings on the Setting Page. - Assign [Camera Control] or [Video Distribution] to authorized users/guest users in [Basic] > [User Management] > [User Authority]. - Set [Basic] > [Viewer] > [General] > [Default Page] to [Display Viewer]. - To also enable guest users to use the Camera Viewer, set [Basic] > [Viewer] > [Viewer Settings] > [User Authentication] to [Do not authenticate]. • Use one of the following procedures, when you launch the Camera Viewer and a file block security warning is displayed because of an unverified publisher. - Launch the Camera Viewer after executing Windows Update to the latest version, when using the camera in an internet connection environment. - Download the root certificate installer from the Canon download site on a connectable computer and install it in the target environment, when in an environment not connectable to the internet. • Follow the procedure in "Adding the Camera IP Address as a Trusted Site" (P. 32) to add this website to [Trusted sites] in the [Security] settings. • If you are using a web browser other than Internet Explorer or if the Canon Network Camera Addon Module is not correctly installed when using Internet Explorer, the following functions cannot be used. - Receiving/transmitting audio - Receiving/playing H.264 video 208