Canon VB-S800D Mark II Network Camera Operation Guide - Page 243
Restoring Factory Default Settings, Restoring the Initial Settings from a Web Browser
View all Canon VB-S800D Mark II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 243 highlights
Restoring Factory Default Settings If you have forgotten the settings and want to set the camera from the beginning, restore the factory default settings first. It is recommended that you use [Maintenance] > [Backup / Restore] on the Setting Page to create a backup file before restoring the factory default settings (P. 201). Important If you restore default settings, you will become unable to connect to the camera because the administrator account is also initialized. Use the Camera Management Tool to configure the initial settings. Note • Settings can also be backed up using the Camera Management Tool. For details on using the Camera Management Tool, please refer to "Camera Management Tool User Manual". • For factory default settings, please refer to P. 227. 6 Appendix Restoring the Initial Settings from a Web Browser Use [Maintenance] > [General] > [Initialization] > [Network Settings] > [Do not save] on the Setting Page (P. 199). Restoring Factory Default Settings with the Reset Switch on the Camera If you have forgotten or do not know the IP address of the camera or your Administrator password, you cannot operate the camera via the network. In this case, press the reset switch to reset the camera. 1 Turn the camera off. The camera does not have a power switch. To turn the camera on or off, connect or disconnect the power cable. 2 Turn on the power while pushing the reset switch, confirm that the LED lights up, and then release the reset switch after five seconds. The reset switch is located in a recessed area. Push the switch using the tip of a slender object such as a clip. When the LED stops flashing, the reset procedure is complete. HM4x Reset Switch LED 225