Cisco 2948G Hardware Installation Guide - Page 41
On the Catalyst 2948G-GE-TX and 2948G switches, only one power source can
UPC - 746320228884
View all Cisco 2948G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Chapter 1 Product Overview Switch Components A Cisco RPS can only power one switch at a time. If more than one switch fails at the same time, any subsequent switch is not supported by the RPS until the first switch failure is resolved. For more information, refer to the documentation that was included with your RPS. On the Catalyst 2948G switch, you must use a Y cable to connect the switch to two RPS 600 power supplies. Each RPS 600 has status LEDs (PSI and RPS). On the Catalyst 2980G-A switch, each RPS 300 power supply has an individual power cord and has status LEDs (PSI, PWR, and RPS). The RPS uses redundant power supplies. If one of the power supplies in the RPS fails, the RPS will automatically switch over to the other power supply without forcing the switch to reboot. Note On the Catalyst 2948G-GE-TX and 2948G switches, only one power source can supply power to the switch at any one time. When you are using an RPS, unplug the local power cord for the switch. If you are using the local power supply, the RPS can be connected but must not be powered on. The switches can be powered by both the internal power supply and the RPS at the same time. 78-6286-05 Catalyst 2984G, 2948G-GE-TX, and 2980G Switch Hardware Installation Guide 1-13