Cisco 2948G Hardware Installation Guide - Page 71
Appendix A, Specifications, Step 1
UPC - 746320228884
View all Cisco 2948G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Chapter 3 Installing the Switch Connecting to 10/100 and 10/100/1000 Ports To connect the switch to 10BASE-T, 100BASE-TX, or 1000BASE-T devices, follow these steps: Step 1 When connecting to servers, workstations, and routers, insert a twisted-pair straight-through cable in a front-panel RJ-45 connector, as shown in Figure 3-15. When connecting to switches or repeaters, insert a twisted-pair crossover cable. (See the Appendix A, "Specifications," for cable-pinout descriptions.) Note When connecting to 1000BASE-T devices, be sure to use a four twisted-pair, Category 5 cable. Figure 3-15 Connecting to a 10/100 or 10/100/1000 Port 98654 STATUS Catalyst 2948G Step 2 Insert the other cable end in an RJ-45 connector on the target device. 78-6286-05 Catalyst 2984G, 2948G-GE-TX, and 2980G Switch Hardware Installation Guide 3-21