Cisco 2948G Hardware Installation Guide - Page 86
Connecting To an SFP Module
UPC - 746320228884
View all Cisco 2948G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
Connecting To an SFP Module Chapter 4 Configuring the Gigabit Ethernet Ports Figure 4-6 Patch Cord Installation To equipment To cable plant 13089 Connecting To an SFP Module This section describes how to connect to an SFP module. For instructions about how to install or remove an SFP module, refer to the Cisco Small Form-Factor Pluggable Modules Installation Notes (not orderable but is available on Cisco.com) and to the documentation that came with your SFP module. Table 4-4 lists the SFP modules supported by the Catalyst 2948G-GE-TX switch. Table 4-4 Supported SFP Modules SFP Type Fiber-optic 1000BASE-LX Fiber-optic 1000BASE-SX Fiber-optic 1000BASE-ZX Copper 1000BASE-T Coarse Wave Division Multiplexing (CWDM) fiber-optic SFP modules Model Number GLC-LS-SM= GLC-SX-MM= GLC-ZX-SM= GLC-T= CWDM-SFP-1470= CWDM-SFP-1490= CWDM-SFP-1510= CWDM-SFP-1530= CWDM-SFP-1550= CWDM-SFP-1570= CWDM-SFP-1590= CWDM-SFP-1610= 4-12 Catalyst 2984G, 2948G-GE-TX, and 2980G Switch Hardware Installation Guide 78-6286-05