Cisco 2948G Hardware Installation Guide - Page 83
Removing GBICs
UPC - 746320228884
View all Cisco 2948G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Chapter 4 Configuring the Gigabit Ethernet Ports Installing, Removing, and Maintaining GBICs Figure 4-4 Connecting the SC-Type Connector Light out of fiber Keys Cable Light into fiber ReceiveTrransmitter Receptacle 17110 Key slots Note If you are using the LX/LH GBIC with MMF, you need to install a patch cord between the GBIC and the MMF cable. See the "Patch Cord" section on page 4-10 for details. Removing GBICs Note If you are removing the GBIC from an online switch, enter the show port command to verify the type of GBIC that is installed. To remove a GBIC, perform these steps: Step 1 Step 2 Disconnect the fiber-optic cable from the GBIC SC-type connector. Release the GBIC from the slot by simultaneously squeezing the plastic tabs (one on each side of the GBIC). 78-6286-05 Catalyst 2984G, 2948G-GE-TX, and 2980G Switch Hardware Installation Guide 4-9