Cisco 2948G Hardware Installation Guide - Page 93
Identifying Startup Problems
UPC - 746320228884
View all Cisco 2948G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Chapter 5 Troubleshooting the Installation Identifying Startup Problems If you encounter a problem in performing any of the above checks, you should contact a customer service representative. Identifying Startup Problems LEDs indicate all system states in the startup sequence. By checking the LEDs, you can determine when and where the system failed in the startup sequence. If you have problems after the switch is powered on and the startup sequence is complete, refer to the software configuration guide for your switch. After you connect the power cord to the Catalyst 2948G, 2948G-GE-TX, or 2980G switches, follow these steps: Step 1 Step 2 Step 3 You should immediately hear the system fans begin to operate. If you do not, see the "Troubleshooting the Power Supply" section on page 5-4. If you determine that the power supplies are functioning normally and that the fans are faulty, contact a customer service representative. Check the power supply LEDs as follows: • The power supply LED should turn green immediately when power is applied to the switch. The LED should remain on during normal system operation. • If the LED turns amber, see the section, "Troubleshooting the Power Supply" section on page 5-4. Check that the LEDs on the front panel light as follows: • The STATUS LED flashes amber once and stays amber during diagnostic boot tests. It turns green when the switch is operational (on line). If the system software is unable to start up, this LED stays amber. • The Link LED flashes amber once after diagnostic boot tests, and turns green when the module is operational (on line). If no signal is detected, the Link LED turns off. The Link LED blinks amber continuously if the port is bad. Note After the diagnostic boot tests, the single flash of amber on the Link LED may occur too quickly to be detected visually. • If a STATUS LED is red or amber, contact a customer service representative for instructions. 78-6286-05 Catalyst 2984G, 2948G-GE-TX, and 2980G Switch Hardware Installation Guide 5-3