Cisco 2948G Hardware Installation Guide - Page 67
Attaching the RPS Connector Cover, Mounting the Switch on a Wall,
UPC - 746320228884
View all Cisco 2948G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Chapter 3 Installing the Switch Installing the Catalyst 2948G-GE-TX Switch Attaching the RPS Connector Cover If you are not using a Cisco RPS with your switch, use the two Phillips pan-head screws to attach the RPS connector cover to the back of the switch before you mount it, as shown in Figure 3-13. Warning If an RPS is not connected to the switch, install an RPS connector cover on the back of the switch. Statement 265 Figure 3-13 Attaching the RPS Connector Cover on the Catalyst 2948G-GE-TX Switch 1.6A-100R>09A-A2T0,IN05GV0-~60 HZ [email protected] 98668 1 2 3 1 Phillips pan-head screws 2 RPS connector cover 3 RPS connector Mounting the Switch on a Wall For the best support of the switch and cables, make sure the switch is attached securely to wall studs or to a firmly attached plywood mounting backboard. Mount the switch with the front panel facing up, as shown in Figure 3-14. 78-6286-05 Catalyst 2984G, 2948G-GE-TX, and 2980G Switch Hardware Installation Guide 3-17