Cisco 2948G Hardware Installation Guide - Page 44
Site Power Requirements and Heat Dissipation - specifications
UPC - 746320228884
View all Cisco 2948G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Site Power Requirements and Heat Dissipation Chapter 2 Site Planning Site Power Requirements and Heat Dissipation Note Catalyst 2948G, 2948G-GE-TX, and 2980G switches have internal power supplies. All of the switches support Cisco Redundant Power System (RPS) for redundant operation. This section provides site power requirements and heat dissipation specifications for the Catalyst 2948G, 2948G-GE-TX, and 2980G switches. You should verify site power before you install a switch. Power requirements can vary for each Catalyst switch. Knowing the power requirements can be useful for planning the power distribution system needed to support the switches. Heat specifications are used for determining the air-conditioning requirements for an installation. Note Refer to the Site Preparation and Safety Guide for site power requirements, preinstallation requirements, and EMI recommendations. Table 2-1 describes the power requirements and heat dissipation specifications for the Catalyst 2948G, 2948G-GE-TX, and 2980G switches. Table 2-1 Power Requirements and Heat Dissipation Specifications Model Number/ Module Type Catalyst 2948G switch Catalyst 2948G-GE-TX switch Power Supply Output (Watts) 120 156 AC Input Power Heat Diss (Watts) (BTU/Hr) 200 645 130 445 AC Input Current (Amps) 90 VAC: 2.0 120 VAC: 1.6 180 VAC: 1.0 240 VAC: 0.9 100 VAC: 1.5 240 VAC: 0.8 Catalyst 2984G, 2948G-GE-TX, and 2980G Switch Hardware Installation Guide 2-2 78-6286-05