Cisco 2948G Hardware Installation Guide - Page 60
Rack-Mounting the Catalyst 2948G-GE-TX Switch, Removing Screws from the Switch
UPC - 746320228884
View all Cisco 2948G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Installing the Catalyst 2948G-GE-TX Switch Chapter 3 Installing the Switch To install a Catalyst 2948G-GE-TX switch, follow the steps described in these procedures: • Rack-Mounting the Catalyst 2948G-GE-TX Switch, page 10 • Wall-Mounting the Catalyst 2948G-GE-TX Switch, page 16 • Mounting the Catalyst 2948G-GE-TX Switch on a Table or Shelf, page 19 Rack-Mounting the Catalyst 2948G-GE-TX Switch To install a Catalyst 2948G-GE-TX switch in a 19-inch rack (24-inch racks require optional mounting hardware), follow the instructions described in these procedures: • Removing Screws from the Switch, page 10 • Attaching Brackets to the Switch, page 11 • Mounting the Switch in a Rack, page 14 • Attaching the Cable Guide, page 15 • Attaching the Brackets to the Switch for Wall-Mounting, page 16 • Attaching the RPS Connector Cover, page 17 • Mounting the Switch on a Wall, page 17 • Mounting the Catalyst 2948G-GE-TX Switch on a Table or Shelf, page 19 Note Installing the switch in a 24-inch rack requires an optional bracket kit not included with the switch. You can order a kit containing the 24-inch rack-mounting brackets and hardware (order part number RCKMNT-1RU=) from Cisco. Removing Screws from the Switch If you plan to install the switch in a rack, you must first remove screws in the switch chassis so that mounting brackets can be attached. Figure 3-3 shows how to remove the chassis screws from the switch. 3-10 Catalyst 2984G, 2948G-GE-TX, and 2980G Switch Hardware Installation Guide 78-6286-05