Compaq ProLiant 5500 Compaq ProLiant 5500 Setup and Installation Guide Pentium - Page 120
Determining Cabling Needs, IDE Controller
![]() |
View all Compaq ProLiant 5500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
7-5 Determining Cabling Needs To determine the SCSI cables needed for your application, follow the procedure below: 1. Determine whether the cabling needs are internal or external. 2. Determine whether external cabling needs are for primary storage (hard drive) or for secondary storage (tape drive or CD-ROM in the removable media bay). 3. Identify the controller type. 4. Identify the drive type, drive cage, and expansion slot to be used. t Wide-Ultra SCSI-3 Hard Drive t Fast-Wide SCSI-2 Hard Drive t Fast SCSI-2 Hard Drive t Tape Drive t SCSI CD-ROM 5. Refer to the appropriate entry in the SCSI Cable Usage Matrix in this chapter to determine the correct usage and routing of the cables for your configuration. NOTE: Only those controllers listed in the SCSI Cable Usage Matrix are supported by Compaq ProLiant 5500 servers. For the latest information on SCSI controllers and configurations supported on the Compaq ProLiant 5500 server, see the following URL: www.compaq.com. IDE Controller Compaq ProLiant 5500 servers ship standard with CD-ROM drives in the removable media bay. Figure 7-4 shows the connection for the CD-ROM signal cable and power cable. Compaq ProLiant 5500 Servers Setup and Installation Guide For use with Intel Pentium II Xeon processor-based servers only
![](/manual_guide/products/compaq-proliant-5500-compaq-proliant-5500-setup-installation-guide-pentium-ii-xeon-processorbased-servers-eeb44d9/120.png)