Compaq ProLiant 5500 Compaq ProLiant 5500 Setup and Installation Guide Pentium - Page 21
System Memory, Expansion Slots, Media Bays
![]() |
View all Compaq ProLiant 5500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
1-2 Introduction System Memory s ECC (Error Checking and Correcting Memory) with single-bit error corrections and detection down to a single DIMM, and multi-bit error detection down to the memory bank s Supports EDO buffered, 60-ns or faster refreshed DIMMs s Expandable to 4 GB (16 X 256 MB DIMMs) s Supports up to 4 memory banks; each bank consists of 4 DIMMs. One bank is installed or removed at a time. Each bank must have four DIMMs of the same size and speed. Expansion Slots Seven I/O expansion slots: s Six 32-bit PCI slots (one is populated with a Compaq Netelligent 10/100 TX PCI UTP Controller) s One shared PCI/ISA slot Media Bays The Compaq ProLiant 5500 server can house up to 11 mass storage devices. s Internal Hot-Plug Drive Bay t The ProLiant 5500 internal hot-plug drive cage can be configured with seven 1-inch drives or six 1.6-inch drives. For further information about media bay configuration, see Chapter 7, "Cabling." NOTE: Optional Duplex Drive Cage Kit may be purchased separately. s Internal Removable Media Bay Area The four ProLiant 5500 internal removable media bays support the following: t One bay occupied by a 1.44-MB diskette drive t One bay occupied by a 24 X IDE CD-ROM drive t Two half-height 5.25-inch drive bays For use with Intel Pentium II Xeon processor-based servers only
![](/manual_guide/products/compaq-proliant-5500-compaq-proliant-5500-setup-installation-guide-pentium-ii-xeon-processorbased-servers-eeb44d9/21.png)