Compaq ProLiant 5500 Compaq ProLiant 5500 Setup and Installation Guide Pentium - Page 70
counterclockwise, releasing the side tabs and pulling up as shown
![]() |
View all Compaq ProLiant 5500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
4-5 1. To add a processor, identify the processor locations as shown in Figure 4-2. NOTE. Processors can be installed in any processor socket. All four processor sockets must have either a processor module or a terminator board installed for proper bus termination. 4 3 2 1 Figure 4-2. Processor locations 2. Remove one of the terminator boards by turning the retaining knob counterclockwise, releasing the side tabs and pulling up as shown in Figure 4-3. Compaq ProLiant 5500 Servers Setup and Installation Guide For use with Intel Pentium II Xeon processor-based servers only
![](/manual_guide/products/compaq-proliant-5500-compaq-proliant-5500-setup-installation-guide-pentium-ii-xeon-processorbased-servers-eeb44d9/70.png)
4-5
Compaq ProLiant 5500 Servers Setup and Installation Guide
For use with Intel Pentium II Xeon processor-based servers only
1.
To add a processor, identify the processor locations as shown in
Figure 4-2.
NOTE
.
Processors can be installed in any processor socket. All four processor
sockets must have either a processor module or a terminator board installed
for proper bus termination.
1
2
3
4
Figure 4-2.
Processor locations
2.
Remove one of the terminator boards by turning the retaining knob
counterclockwise, releasing the side tabs and pulling up as shown in
Figure 4-3.