Compaq ProLiant 5500 Compaq ProLiant 5500 Setup and Installation Guide Pentium - Page 139
Example 1, Using Integrated SCSI Port 1 and Port 2 for, Hard Drives with SCSI Input 1 Connected
![]() |
View all Compaq ProLiant 5500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
7-24 Cabling Example 1: Using Integrated SCSI Port 1 and Port 2 for Hard Drives with SCSI Input 1 Connected to the Removable Media Bay 1. Install the Duplex Enabler Board on the back of the Drive Cage, if not already installed. 2. Connect 19-inch point-to-point non-terminated SCSI cable (199606007), from the SCSI Port 1 to SCSI Input 0 of the duplex board. Connect another 19-inch point-to-point non-terminated SCSI cable (199606-007) from SCSI Port 2 to SCSI Input 1 of the duplex board. These connections are shown in Figures 7-13 and 7-14. 3. Use 22-inch 3-device non-terminated SCSI cable (199616-010), supplied with server, to connect from the duplex enabler board to the removable media bay. 3 2 1 4 5 8 3 3 2 2 1 6 1 10 0 0 9 7 Figure 7-13. Example 1: Configuration diagram For use with Intel Pentium II Xeon processor-based servers only
![](/manual_guide/products/compaq-proliant-5500-compaq-proliant-5500-setup-installation-guide-pentium-ii-xeon-processorbased-servers-eeb44d9/139.png)