Dell DX6004S Hardware Owner's Manual - Page 24
continued, E122D Memory
View all Dell DX6004S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Table 1-1. LCD Status Messages (continued) Code E122C E122D E122E E1310 E1311 E1313 E1410 Text Causes Corrective Actions CPU Power Fault. Power cycle AC. A power fault was detected when powering up the processor. Remove AC power to the system for 10 seconds and restart the system. If the problem persists, see "Getting Help" on page 161. Memory One of the memory Regulator # regulators has failed. Failed. Reseat DIMMs. Reseat the memory modules. See "Troubleshooting System Memory" on page 145. On-board regulator failed. Call support. One of the on-board voltage regulators failed. Remove AC power to the system for 10 seconds and restart the system. If the problem persists, see "Getting Help" on page 161. Fan ## RPM exceeding range. Check fan. RPM of specified fan is outside of the intended operating range. See "Troubleshooting System Cooling Problems" on page 143. Fan module ## RPM exceeding range. Check fan. RPM of specified fan in specified module is outside of intended operating range. See "Troubleshooting System Cooling Problems" on page 143. Fan redundancy The system is no longer lost. Check fan redundant. Another fans. fan failure would put the system at risk of over-heating. Check LCD for additional scrolling messages. See "Troubleshooting a Fan" on page 144. Internal Error Specified processor has an Remove AC power to the detected. internal error. The error system for 10 seconds and Check "FRU X". may or may not have been restart the system. caused by the processor. If the problem persists, see "Getting Help" on page 161. 24 About Your System