Dell DX6004S Hardware Owner's Manual - Page 41
Plug & Play, Link Width is
View all Dell DX6004S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Table 1-2. System Messages (continued) Message Causes No boot sector on hard drive. Incorrect configuration settings in System Setup program, or no operating system on hard drive. No timer tick interrupt. Faulty system board. PCIe Training Faulty or improperly Error: Expected installed PCIe card in the Link Width is x, specified slot. Actual Link Width is y. Plug & Play Configuration Error. Error encountered in initializing PCIe device; faulty system board. Quad rank DIMM detected after single rank or dual rank DIMM in socket. Invalid memory configuration. Corrective Actions Check the hard drive configuration settings in the System Setup program. See "Using the System Setup Program and UEFI Boot Manager" on page 51. If necessary, install the operating system on your hard drive. See your operating system documentation. See "Getting Help" on page 161. Reseat the PCIe card in the specified slot number. See "Troubleshooting an Expansion Card" on page 149. If the problem persists, see "Getting Help" on page 161. Install the NVRAM_CLR jumper in the clear position (pins 1 and 3) and reboot the system. See Figure 6-1 for jumper location. If the problem persists, see "Troubleshooting an Expansion Card" on page 149. Ensure that the memory modules are installed in a valid configuration. See "General Memory Module Installation Guidelines" on page 98. About Your System 41