Dell PowerEdge 4350 Dell PowerEdge 4350 Systems Installation and Troubleshooti - Page 134

diskette drive slot

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208

9-6
Dell PowerEdge
4350 Systems Installation and Troubleshooting Guide
6.
Check all cable connections that may have been loosened during this procedure.
Arrange cables so that they will not catch on the computer covers or block the air-
flow of the fans or cooling vents.
7.
Replace the front bezel.
8.
Reconnect the computer and peripherals to their electrical outlets, and turn them
on.
9.
Test the CD-ROM drive to verify that it is functioning properly.
,QVWDOOLQJ±WKH±’LVNHWWH±’ULYH
Use the following procedure to install or replace the diskette drive:
1.
Turn off the system, including any attached peripherals, and disconnect the sys-
tem from its electrical outlet.
2.
Attach the diskette drive to the diskette drive bracket.
Place the diskette drive on top of the bracket with the left edge of the drive
aligned with the two mounting stays on the left side of the bracket (see
Figure 9-6). Press the diskette drive firmly against the stays, and pull the latch on
the bracket up into the engaged position to secure the diskette drive to the
bracket.
)LJXUH±¾¶»µ±±,QVWDOOLQJ±WKH±’LVNHWWH±’ULYH
diskette drive
diskette drive
bracket
bracket latch
control panel
diskette drive slot
interposer card
mounting stays
interposer
card cable