Dell PowerEdge R840 EMC Installation and Service Manual - Page 110
Installing IDSDM or vFlash module
![]() |
View all Dell PowerEdge R840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
Figure 76. Removing IDSDM or vFlash module NOTE: There are two dip switches on the IDSDM or vFlash module for write-protection. NOTE: If you are replacing the IDSDM or vFlash module, remove the microSD cards. Next steps Install the IDSDM or vFlash module. Installing IDSDM or vFlash module Prerequisites 1. Follow the safety guidelines listed in Safety instructions on page 44. 2. Follow the procedure listed in Before working inside your system on page 45. 3. Remove the air shroud. 4. Remove the expansion card riser 1. Steps 1. Locate the IDSDM or vFlash connector on riser 1. 2. Align IDSDM or vFlash module with the connector on the riser. 3. Push IDSDM or vFlash module until it is firmly seated in the connector on the riser. 110 Installing and removing system components
![](/manual_guide/products/dell-poweredge-r840-emc-installation-service-manual-fc1c869/110.png)