Dell PowerEdge R840 EMC Installation and Service Manual - Page 96
Installing a PCIe expansion card
![]() |
View all Dell PowerEdge R840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
Installing a PCIe expansion card Prerequisites 1. Follow the safety guidelines listed in Safety instructions on page 44. 2. Follow the procedure listed in Before working inside your system on page 45. 3. Remove the air shroud. Steps 1. Unpack the expansion card and prepare it for installation. For instructions, see the documentation accompanying the card. 2. If you are installing a new card, remove the filler bracket. a. Open the blue expansion card retention latch lock. b. Slide the filler bracket out of the system. Figure 60. Removing the filler bracket NOTE: Store the filler bracket for future use. Filler brackets must be installed in empty expansion card slots to maintain FCC certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system. 3. Holding the card on the edges, align the card with the expansion card connector on the system board. 4. Press the expansion card firmly into the expansion card connector on the system board until the card is fully seated. 5. Close the blue expansion card retention latch. 96 Installing and removing system components
![](/manual_guide/products/dell-poweredge-r840-emc-installation-service-manual-fc1c869/96.png)