Dell PowerEdge R840 EMC Installation and Service Manual - Page 62
Installing a drive blank
![]() |
View all Dell PowerEdge R840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Figure 35. Removing a drive blank Next steps 1. Install a drive or drive blank. Installing a drive blank Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure listed in Before working inside your system. 3. If installed, remove the front bezel. CAUTION: To maintain proper system cooling, drive blanks must be installed in all empty drive slots. CAUTION: Mixing drive blanks from previous generations of PowerEdge servers is not supported. Steps Slide the drive blank into the drive slot until the release button clicks into place. Figure 36. Installing a drive blank Next steps 1. Install the front bezel, if applicable. 2. Follow the procedure listed in After working inside your system. 62 Installing and removing system components
![](/manual_guide/products/dell-poweredge-r840-emc-installation-service-manual-fc1c869/62.png)