Dell PowerEdge R840 EMC Installation and Service Manual - Page 170
Table 50. AC PSU status indicator codes continued, Power Performance EPP label. Mixing PSUs
![]() |
View all Dell PowerEdge R840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
Table 50. AC PSU status indicator codes (continued) Power indicator codes Condition condition and unexpected system shutdown. To change from a high output configuration to a low output configuration or conversely, you must turn off the system. CAUTION: AC PSUs support both 240 V and 120 V input voltages except for Titanium PSUs, which support only 240 V. When two identical PSUs receive different input voltages, they can output different wattages, and trigger a mismatch. CAUTION: If two PSUs are used, they must be of the same type and have the same maximum output power. CAUTION: Combining AC and DC PSUs is not supported and triggers a mismatch. Figure 125. DC PSU status indicator 1. DC PSU status indicator Table 51. DC PSU status indicator codes Power indicator codes Green Blinking amber Not illuminated Blinking green 170 System diagnostics and indicator codes Condition A valid power source is connected to the PSU, and the PSU is operational. Indicates a problem with the PSU. Power is not connected to the PSU. When hot-plugging a PSU, the PSU indicator blinks green. This indicates that there is a PSU mismatch about efficiency, feature set, health status, or supported voltage. CAUTION: If two PSUs are installed, both the PSUs must have the same type of label; for example, Extended Power Performance (EPP) label. Mixing PSUs from previous generations of PowerEdge servers is not supported, even if the PSUs have the same power rating. This results in a PSU mismatch condition, or failure to turn on the system.
![](/manual_guide/products/dell-poweredge-r840-emc-installation-service-manual-fc1c869/170.png)