Dell PowerEdge T30 Owners Manual - Page 58
Removing a hard drive from a hard drive carrier
![]() |
View all Dell PowerEdge T30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
2. Insert and push the hard drive into the hard drive bay until it clicks into place. Figure 24. Installing a 3.5-inch hard drive carrier in the hard drive bay NOTE: For information on cabling the hard drives, see the System Information Label on the system cover. NOTE: Ensure that SATA cables with a right angle connector are used to connect the hard drives in the hard drive bay. Next steps 1. If applicable, connect the power and data cables to the hard drive(s). 2. Follow the procedure listed in the After working inside your system section. Related tasks Before working inside your system After working inside your system Removing a hard drive from a hard drive carrier Prerequisites CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product. 1. Follow the safety guidelines listed in the Safety instructions section. 2. Follow the procedure listed in the Before working inside your system section. 3. Disconnect the power and data cables from the hard drive(s). 4. Remove the hard drive from the hard drive cage or hard drive bay. Steps To release the hard drive, flex the sides of the hard drive carrier and push the hard drive out of the carrier. 58 Installing and removing system components
![](/manual_guide/products/dell-poweredge-t30-owners-manual-3708331/58.png)