Dell TL2000 User Guide - Page 156

a77ug193 2. Quiesce all drives, then unload all drives. 3. Click Service Library, then Key Path Diagnostics. Figure 5-58. Service Library: Perform Key Path Diagnostics page 4. Click Start Tests. Note: If you have just enabled encryption on your library, wait for all LME drives to be displayed in the table and the Start Tests button to become active. Each test will show a result of "Passed" or "Failed". If a test fails the remaining tests will not be executed, and the test will show a result of "N/A". The IP Address may show "N/A" for the following reasons: 1. Drive is not encryption capable. 2. EKM Server Settings, on the Configure Library → Encryption page, are not configured correctly. Test results will clear: v When the test is rerun v When the library is rebooted The time and date of the last test will appear below the Key Path Diagnostics screen. If any of the tests fail, refer to Chapter 7, "Troubleshooting," on page 7-1 for additional information. Service Library: Upgrade Firmware Note: Library firmware and tape drive firmware are verified and released together. When updating to the latest firmware, verify that all installed components such as tape drive(s), and library are at the latest levels noted on the Support web site. Mixing different levels of library and tape drive firmware is not supported and may cause unpredictable results. This page displays the current library and drive firmware versions. Firmware can be downloaded to the host then uploaded to the drive or library by using this page. Click Browse... to choose the firmware file you have downloaded from the web site for the library or drive you want to update. (You can update only one device at a time). Be sure you choose the correct firmware for the library or drive type. Click the Update button to initiate the file transfer and firmware update. 5-62 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide