Dell TL2000 User Guide - Page 172
Problem, Solution, ENCRYPTION, Service, Drive Power, ERROR CODES, FRONT PANEL LEDs - driver problem
View all Dell TL2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 172 highlights
Table 7-1. Troubleshooting table (continued) Problem Solution ENCRYPTION Encryption Error: Displayed when the drive detects an error associated with an encryption operation - if the problem occurred while the tape drive was writing data to, or reading data from, tape 1. Check the host application to ensure the Encryption Key Manager (EKM) application is providing the correct encryption key. v Refer to the "Drive Sense Data" on page C-6 returned for an encryption operation. v Retry the encryption operation after the EKM application problems have been resolved. 2. Check the operation of the tape drive by resetting the drive (Operator Control Panel: Service → Service → Drive Power) and running POST. v Refer to the error code displayed on the Operator Control Panel if the drive resets and POST fails. v Retry the encryption operation if the drive reset and POST complete without errors. 3. Check the media. v Ensure the correct media is being used. Data encryption is supported with LTO Ultrium 4 Data Cartridges only. v Retry the encryption operation with the tape cartridge in another encryption enabled drive. Replace the media if the problem repeats with the same tape cartridge in multiple drives. If the problem occurred while the tape drive was running POST or diagnostics, replace the drive. The error code clears with the first attempted write/read after the encryption key is changed, or when the drive is placed in maintenance mode. Encryption-related error is posted Check the EKM application's error logs, device driver logs, tape library error logs, and tape drive error logs for entries that are related to encryption. See "Service Library: View Logs" on page 5-58, "Service Library: View Drive Logs" on page 5-59, Chapter 8, "Error Codes," on page 8-1, and "Drive Sense Data" on page C-6. Connection problem with the Dell Encryption Key Manager (EKM) If you are using library-managed encryption, perform the Key Path Diagnostic (see "Service Library: Key Path Diagnostics" on page 5-61) if this feature is available. If the test fails, a problem could exist with the IP address, the Ethernet cable, or the EKM server. Perform the following: 1. Check the Ethernet connection between the library and the EKM server. 2. Check the TCP/IP configuration of the library and the server. 3. Check that the EKM is correctly installed and configured, and that the EKM application is properly started (refer to your EKM documentation). 4. Ensure that the tape drive is registered in the EKM (refer to your EKM documentation). 5. Ensure that a default key label is defined in the EKM (refer to your EKM documentation). There is an error code in the error log. If you are using application-managed encryption, check your tape backup application documentation for a similar test. ERROR CODES Most library or drive errors will result in an error code or error message on the Operator Control Panel display. An error code history is maintained in the library or drive error log. See "Service Library: View Drive Logs" on page 5-59 for how to get the error log over the Operator Control Panel and "Service Library: View Logs" on page 5-58 to view logs using the Web User Interface. Look up the error code and try to resolve (see Chapter 8, "Error Codes," on page 8-1 and/or Appendix C, "Sense Data," on page C-1). FRONT PANEL LEDs 7-2 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide