Dell TL2000 User Guide - Page 191

Table 8-2. Sub error codes (continued) 39 Error during sled positioning without sensor 3A Error during elevator movement without sensor 3B Error slot position sensor not found 40 Movement to/from slot failed 41 Error during first slider movement 42 Error during first gripper movement 43 Error during second slider movement 44 Error during second gripper movement, get range failed 45 Error during third slider movement, move home failed 46 Error during set hold current to avoid torsion 47 Negative direction blocked 48 Positive direction blocked 49 Possible motor defect, because both directions blocked 4A Cartridge present sensor defect 4B Inventory lost, because destination possibly full 4C Inventory lost, because source may be empty 4D Could not pull tape out of slot from magazine 4E Unexpected tape on elevator, possible inventory lost 50 Preposition to drive failed 51 Elevator movement to home sensor failed. 52 Sled movement to home sensor failed. 53 Error during sled movement to drive position. 54 Error during rotation to drive position. 55 Error during elevator movement in drive position. 56 Error during sled movement to rotation position. 57 Error during rotation to end position. 60 Move from/to drive failed. 61 Error during first slider movement. 62 Error during first gripper movement. 63 Error during second slider movement. 64 Error during second gripper movement, get range failed. 65 Error during third slider movement, move home failed. 70 Release magazine failed. 71 Error during sled movement to rotation position. 72 Error during rotation to unlock position. 73 Error during move sled to block. 80 Opening I/O slot failed. Chapter 8. Error Codes 8-9