Dell TL2000 User Guide - Page 195

Table 8-3. Warning Events (continued) 81 Fan Alert. 82 Clean request from drive. 83 Media Attention. 84 Drive reported warning or critical tape alert flag. 85 Network problem. 86 Not enough cleaning cartridges present to autoclean. 87 Drive disabled because it is not supported for use in this library. 88 Drive firmware unchanged after upgrade. 89 Power Supply Fan operation warning. 8A Power Supply has failed. 8B Power supply has failed. 8C Invalid Robotic Code. 8E Cleaning tape nearly expired. 8F I2C bus recovery. 92 VPD data have been restored from EEPROM. DB External cooling fan error (fan motion has stopped). Check network connections, configuration, and settings. Insert additional cleaning cartridges to the empty reserved slots. Check drive type and install only supported drives. This is normal if the old and new drive firmware are the same version. Check the power supply status. Check the power supply status and replace the failed power supply. Check the power supply status and replace the failed power supply. Install the latest version of library firmware. Continue using cleaning cartridge until it is expired, then replace the expired cleaning cartridge with a new cleaning cartridge. Run library System Test. This is normal when the VPD has been restored EEPROM. The subcode indicates which drive sled fan is affected Refer to "Isolating Drive Sled Problems" on page 7-9. Subcode 01: drive sled #1(bottom) Subcode 02: drive sled #2 DC I2C Bus Failure DD Power Supply x fan has failed, Redundancy may be at risk The subcode indicates which power supply fan is affected Refer to "Isolating a Power Supply Problem" on page 7-7. Subcode 01: 1st PS fan from bottom Subcode 02: 2nd PS fan from bottom DF Power Good signal changed from 2 to 1 Power Supplies F6 No drive installed. A drive has never been installed. Install at least one drive. Chapter 8. Error Codes 8-13