Dell TL2000 User Guide - Page 79
Primary IP address IPv4 or IPv6 - default ip address
View all Dell TL2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
a77ug192 Figure 4-24. Configure Library: Encryption Activation screen 4. Select Enable SSL for EKM to enable Secure Sockets Layer for the Dell Encryption Key Manager application. 5. Select an Encryption method for each logical library. v Without an encryption license key, select None or Application Managed Encryption. v With an encryption license key, select Library Managed Encryption. 6. Select an Encryption policy for each logical library. v Encrypt All: This is the default policy. It encrypts all cartridges using the default data keys specified in the EKM. This setting applies to all drives in a TL2000/TL4000 logical library. v Internal Label - Selective Encryption: Check your tape backup software application documentation to see if this feature is supported. v Internal Label - Encrypt All: Check your tape backup software application documentation to see if this feature is supported. 7. A primary and secondary EKM server can be set for each logical library. Each partition has its own Encryption and EKM settings. Maintaining primary and secondary EKM servers is desired for maximum availability of encrypted backup and recovery. These settings are required for Library Managed Encryption only. Enter the EKM Server Setting information. Note: The IP address of the Encryption Key Manager (EKM) host must be consistent with the library Network settings. This means if the library is set to IPV4 only network support, the EKM host must be an IPV4 address. If the Dell PowerVault library is required to function in a mixed network environment the library must be set to IPv4 + IPv6. v Primary IP address (IPv4 or IPv6): Enter the IP address of the primary EKM server. v Primary TCP port: After entering the Primary IP address, the library will automatically set the value of the Primary TCP port. v Secondary IP address (IPv4 or IPv6): Enter the IP address of the secondary EKM server. v Secondary TCP port: After entering the Secondary IP address, the library will automatically set the value of the Secondary TCP port. Note: The Default Port for TCP (SSL disabled) is 3801. The Default Port for SSL is 443. These values are the default values set by the library. They can be changed depending on the user configuration but the user has to make sure they match the EKM properties file. Note: If SSL is enabled the encryption host configuration will request a SSL port instead of a TCP port. Review your Dell PowerVault Encryption Key Manager User's Guide for instructions to locate the appropriate port settings. 8. Click Activate to apply the changes. Chapter 4. Installation and Configuration 4-23