Epson 3800 Service Manual - Page 106

EPSON Stylus Pro 3800/3800C/3850 4.3.3.12 HOUSING, UPPER 1. Remove the HOUSING, REAR, ASSY. (p95) 2. Remove the HOUSING, FRONT, LEFT. (p97) 3. Remove the HOUSING, FRONT, RIGHT. (p98) 4. Remove the COVER, PRINTER. (p99) 5. Remove the HOUSING, LEFT. (p102) 6. Remove the HOUSING, RIGHT. (p103) 7. Remove the HOUSING, FRONT, UPPER. (p104) 8. Remove the OPERATION, PANEL, ASSY. (p105) 9. Remove the four screws that secure the HOUSING, UPPER to the main unit. „ Three C.B.P. 3 x 8 screws (6 ± 1 kgf.cm) „ One C.B.P. 3 x 12 screw (6 ± 1 kgf.cm) C A U T IO N Note that the LOCK, COVER, ASSY. is attached to the HOUSING, UPPER, and it is connected to the main unit with cables. When removing the HOUSING, UPPER, be careful not to separate it too much from the main unit to avoid damaging the cables. 10. Remove the HOUSING, UPPER upward. CHECK P O IN T When removing the HOUSING, UPPER, push outward on the left and right sides of the HOUSING, UPPER to widen it in order not to hit the drive gear. 11. Remove the LOCK, COVER, ASSY. from the HOUSING, UPPER. (p123) Be sure to insert the four positioning holes of the HOUSING, UPPER over the guide pins on the main unit as shown in Figure 4-19. Revision A positioning point C.B.P. 3x8 positioning point HOUSING, UPPER C.B.P. 3x8 positioning point C.B.P. 3x8 positioning point Figure 4-19. Removing the HOUSING, UPPER C.B.P. 3x12 DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 106