Epson 3800 Service Manual - Page 156
Strengthen Plate, Cr.
UPC - 010343862081
View all Epson 3800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 156 highlights
EPSON Stylus Pro 3800/3800C/3850 12. Remove the COVER, CR. (p150) C A U T IO N Do not disconnect/insert FFCs from/into the connectors at an angle. Doing so may damage, short, or break the terminals in the connector resulting in a breakdown of the elements on the board. 13. Disconnect the all connectors and FFCs from the BOARD ASSY., SUB. 14. Remove the screw that secures the grounding wire of the (MOTOR, INK SELECTER) to the BOARD ASSY., SUB. See Figure 4-85. One C.B.S. 3 x 6 screw (6 ± 1 kgf.cm) 15. Remove the two screws that secure the STRENGTHEN PLATE, CR and remove it. See Figure 4-86. Two C.B.P. 3 x 6 screws (3 ± 0.5 kgf.cm) Insert the positioning hole of the STRENGTHEN PLATE, CR over the guide pin of the CARRIAGE, ASSY. to secure the STRENGTHEN PLATE, CR. See Figure 4-86. BOARD ASSY., SUB Revision A C.B.S. 3 x 6 Secures the HARNESS, Grounding Wire and BOARD ASSY.,SUB grounding wire (MOTOR, INK SELECTOR) Figure 4-85. Removing the BOARD ASSY., SUB STRENGTHEN PLATE, CR positioning point C.B.P. 3 x 6 DISASSEMBLY & ASSEMBLY Figure 4-86. Removing the STRENGTHEN PLATE, CR Disassembly/Assembly Procedure (Group 1) 156