Epson 3800 Service Manual - Page 169

EPSON Stylus Pro 3800/3800C/3850 4.3.11 Removing the Carriage Mechanism 4.3.11.1 CARRIAGE, ASSY. 1. Remove the HOUSING, UPPER. (p106) 2. Remove the COVER, HOUSING, LOWER. (p107) 3. Remove the MOTOR ASSY., CR. (p121) 4. Remove the SCALE, CR. (p130) 5. Remove the PUMP, CAP, ASSY. (p148) 6. Remove the COVER, CR. (p150) 7. Remove the INK, SYSTEM, ASSY. (p151) 8. Remove the PRINT HEAD. (p159) 9. Remove the screw on the rear of the main unit that secures the grounding wire of the MOTOR ASSY., ASF and the MOTOR SSY., PUMP, and release them from the main frame. See Figure 4-106. „ One C.B.S. 3 x 6 screw (9 ± 1 kgf.cm) 10. Push the PULLEY, DRIVEN, ASSY. in the direction of the arrow, and remove the PULLEY, DRIVEN, ASSY. and the BELT, CR from the HOLDER, PULLEY, DRIVEN. See Figure 4-107. Be sure to install the PULLEY, DRIVEN, ASSY. to the HOLDER, PULLEY, DRIVEN so that the protrusion of the PULLEY, DRIVEN, ASSY. is seen as shown in Figure 4-107. Left rear side of the printer C.B.S. 3x6 Revision A Secure the two harnesses together. Top : Grounding Wire (MOTOR ASSY., ASF) Bottom: Grounding Wire (MOTOR ASSY., PUMP) Figure 4-106. Releasing the HARNESS Left front side of the printer HOLDER, PULLEY, DRIVEN BELT, CR protrusion DISASSEMBLY & ASSEMBLY PULLEY, DRIVEN, ASSY. Figure 4-107. Removing the PULLEY, DRIVEN, ASSY. Disassembly/Assembly Procedure (Group 1) 169