Epson 3800 Service Manual - Page 127

EPSON Stylus Pro 3800/3800C/3850 4.3.6.3 RELEASE SENSOR 1. Remove the HOUSING, UPPER. (p106) 2. Manually turn the SPUR GEAR, 22 shown in Figure 4-50 clockwise until the FLAG, DETECTOR, RELEASE goes out of the detection part of the RELEASE SENSOR (put the sensor into not-detecting state). 3. Disconnect the connector from the RELEASE SENSOR. See Figure 4-50. 4. Release the four hooks that secure the RELEASE SENSOR, and remove the RELEASE SENSOR. See Figure 4-50. If the cables have come off the cable guides on the main unit while removing the RELEASE SENSOR, be sure to route the cables correctly referring to Figure 4-50. Route through cable guides Revision A SPUR GEAR, 22 RELEASE SENSOR Detected connector hooks Not Detected DISASSEMBLY & ASSEMBLY RELEASE SENSOR FLAG, DETECTOR, RELEASE Figure 4-50. Removing the RELEASE SENSOR Disassembly/Assembly Procedure (Group 1) 127