Epson 3800 Service Manual - Page 122
Whenever the MOTOR ASSY., CR is replaced
UPC - 010343862081
View all Epson 3800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 122 highlights
EPSON Stylus Pro 3800/3800C/3850 4. Disconnect the connector from the MOTOR ASSY., CR. 5. Remove the two screws that secure the MOTOR ASSY., CR and remove it. Two C.C.S. 3 x 4 screws (6 ± 1 kgf.cm) CHECK P O IN T When removing the C.C.S. 3x4 screws that secure the MOTOR ASSY., CR, use a stubby screw driver or put a screwdriver (with a 140mm or longer shaft is recommended) through the holes on the main frame as shown in Figure 4-44. Be sure to install the MOTOR ASSY., CR to the main frame so that the label on the MOTOR ASSY., CR faces upward. See Figure 4-44. A D JU S TM E N T R E Q U IR E D Whenever the MOTOR ASSY., CR is replaced, the corresponding adjustments must be carried out. See Chapter 5 "ADJUSTMENT" (p190). Overhead view Connector MOTOR ASSY., CR Label C.C.S. 3x4 Revision A DISASSEMBLY & ASSEMBLY Put the screwdriver through this hole. Figure 4-44. Removing the screws from the MOTOR ASSY., CR Disassembly/Assembly Procedure (Group 1) 122