Epson 3800 Service Manual - Page 143

EPSON Stylus Pro 3800/3800C/3850 6. Release the rear end of the TORSION SPRING, 0.15 from the cutout of the main frame in the direction of the arrow, and remove the TORSION SPRING, 0.15 from the GUIDE, PAPER GUIDE, BOARD PAPER, RIGHT. 7. Remove the two screws that secure the GUIDE, PAPER GUIDE, BOARD PAPER, RIGHT. „ Two C.B.P. 3 x 6 screws (9 ± 1 kgf.cm) CHECK P O IN T When removing/installing the C.B.P. 3x6 screws that secure the GUIDE, PAPER GUIDE, BOARD PAPER, RIGHT, use a stubby screw driver or put a screwdriver (with a 110 mm or longer shaft is recommended) through the holes on the FRAME, ASSY., SUB, RIGHT as shown in Figure 4-69. Revision A GUIDE, PAPER GUIDE, BOARD PAPER, RIGHT C.B.P. 3x6 Put the screwdriver through this hole. TORSION SPRING, 0.15 Figure 4-69. Removing the TORSION SPRING, 0.15 and the screw from the GUIDE, PAPER GUIDE, BOARD PAPER, RIGHT DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 143