Epson EPL-8000 User Manual - Page 102
Timeout, other. This option is available only when an IES setting is
View all Epson EPL-8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
Level 2 Options Note: You can also save the settings with the P-CONFIG SAVE option, and then initialize the printer. See the P-CONFIG SAVE option later in this chapter. TIMEOUT This option is available only when the PostScript card is installed. Use this option to specify the time (in seconds) for intelligent emulation switch timeout. When the intelligent emulation switching channel receives no more data, it enters the timeout status. During the timeout it cannot switch to another mode; instead, it prints all data received in the current mode. You can tell when the timeout is over by the display, which switches from showing READY and the current mode to showing PS and the other selected mode. For example, if LJ-3 is the other selected mode, the display shows READY LJ-3 during the timeout and PS&LJ-3 after the timeout. Do not send any data in the new mode until the display changes. You can set a different timeout value for each mode. The factory setting is 30 for PS mode and 10 for OTR (other). This option is available only when an IES setting is selected. Menu/submenu Available options PS or OTR Press the button to select the mode for which you want to change the setting; then press Menu/submenu Available options 5 to 95 (in steps of 5 ) For complete instructions on the intelligent emulation switch, see Chapter 2, Switching the emulation mode. 3-34 SelecType