Epson EPL-8000 User Manual - Page 176
particular printer mode. For example, if you change the I/F
View all Epson EPL-8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 176 highlights
SelecType Problems After turning on the printer, the message START UP ERROR is displayed and your previously selected settings have changed. • This message may appear if you turned off the printer while it was in the process of saving settings made with the FACTORY RESET option in SelecType Level 2. If this occurs, the settings may not have been saved. Run the status sheet to check SelecType settings and reset them if necessary as described in Chapter 3. After changing printer modes, you find that your previous SelecType Level 2 settings for that mode have changed. • You may be trying to set up different SelecType Level 2 configurations for a number of printer modes. This is not possible because SelecType Level 2 settings are not specific to a particular printer mode. For example, if you change the I/F CONFIG setting from PARALLEL to SERIAL in one mode and save it with P-CONFIG SAVE, the change is reflected in all printer modes. However, you can save up to four separate configurations for SelecType Level 1 as macros. 6-30 Troubleshooting