Epson EPL-8000 User Manual - Page 170

Printing Problems The printout is not what you expect. The font you selected with software commands cannot be printed. . The correct orientation (portrait or landscape) may not be selected. Make sure that the orientation (portrait or landscape) matches the selected font. The correct font is not selected if the font does not contain the selected orientation. . The font you selected with your software may not be available. Be sure you have installed the correct font cartridge. Characters not belonging to the selected symbol set are printed. l The expected symbol set may not be selected. Specify the desired symbol set (containing international characters or symbols) with your software or with SelecType. Available symbol sets in SelecType vary depending on the selected printer mode. See Chapter 3 or the Appendixes for each mode for more information. All the text is printed on the same line. l A line feed command is not being sent at the end of each line of text. If the SelecType Level 1 SUB CONFIG has an AUTO LF option in your mode, turn it to ON. l If you are using the parallel interface, you may also be able to correct this problem by setting the SelecType Level 2 AUTOFEED option to ON. See Chapter 3. Text is printed with an extra blank line in between printed lines. l An extra line feed signal is probably being sent. If the SelecType Level l SUB CONFIG option has an AUTO LF option in your mode, turn it to OFF. 6-24 Troubleshooting