Epson LX-300II Reference Guide - Page 22
Adjusting the top-of-form position, Pause, LF/FF, Load/Eject - printer paused
View all Epson LX-300II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Adjusting the top-of-form position The top-of-form position is the position on the page where the printer starts printing. If your printing appears too high or too low on the page, you can use the Micro Adjust mode to adjust the top-of-form position. c Caution: Never use the paper feed knob to adjust the top-of-form position; this may damage the printer or cause it to lose the top-of-form position. 1. Make sure the printer is turned on and paper is loaded. 2. Remove the printer cover. 3. Hold down the Pause button for about three seconds. The printer beeps and the Pause light starts flashing as the printer enters Micro Adjust mode. 4. Press the LF/FF D button to move the top-of-form position higher on the page, or press the Load/Eject U button to move the top-of-form position lower on the page. 22 Paper Handling