HP 6125XLG R2306-HP 6125XLG Blade Switch ACL and QoS Command Reference - Page 25

Parameters Function Description tos tos Specifies a ToS preference. The tos argument can be a number in the range of 0 to 15, or in words: max-reliability (2), max-throughput (4), min-delay (8), min-monetary-cost (1), or normal (0). dscp dscp Specifies a DSCP priority. The dscp argument can be a number in the range of 0 to 63, or in words: af11 (10), af12 (12), af13 (14), af21 (18), af22 (20), af23 (22), af31 (26), af32 (28), af33 (30), af41 (34), af42 (36), af43 (38), cs1 (8), cs2 (16), cs3 (24), cs4 (32), cs5 (40), cs6 (48), cs7 (56), default (0), or ef (46). fragment Applies the rule to only non-first fragments. Without this keyword, the rule applies to all fragments and non-fragments. logging Logs matching packets. This function requires that the module (for example, packet filtering) that uses the ACL supports logging. time-range time-range-name Specifies a time range for the rule. The time-range-name argument is a case-insensitive string of 1 to 32 characters. It must start with an English letter. If the time range is not configured, the system creates the rule. However, the rule using the time range can take effect only after you configure the timer range. For more information about time range, see ACL and QoS Configuration Guide. vpn-instance vpn-instance-name Applies the rule to packets in a VPN instance. The vpn-instance-name argument is a case-sensitive string of 1 to 31 characters. If no VPN instance is specified, the rule applies only to non-VPN packets. If the protocol argument is tcp (6) or udp (7), set the parameters shown in Table 8. Table 8 TCP/UDP-specific parameters for IPv4 advanced ACL rules Parameters Function source-port operator port1 [ port2 ] Specifies one or more UDP or TCP source ports. destination-port operator port1 [ port2 ] Specifies one or more UDP or TCP destination ports. Description The operator argument can be lt (lower than), gt (greater than), eq (equal to), neq (not equal to), or range (inclusive range). The port1 and port2 arguments are TCP or UDP port numbers in the range of 0 to 65535. port2 is needed only when the operator argument is range. TCP port numbers can be represented as: chargen (19), bgp (179), cmd (514), daytime (13), discard (9), domain (53), echo (7), exec (512), finger (79), ftp (21), ftp-data (20), gopher (70), hostname (101), irc (194), klogin (543), kshell (544), login (513), lpd (515), nntp (119), pop2 (109), pop3 (110), smtp (25), sunrpc (111), tacacs (49), talk (517), telnet (23), time (37), uucp (540), whois (43), and www (80). UDP port numbers can be represented as: biff (512), bootpc (68), bootps (67), discard (9), dns (53), dnsix (90), echo (7), mobilip-ag (434), mobilip-mn (435), nameserver (42), netbios-dgm (138), netbios-ns (137), netbios-ssn (139), ntp (123), rip (520), snmp (161), snmptrap (162), sunrpc (111), syslog (514), tacacs-ds (65), talk (517), tftp (69), time (37), who (513), and xdmcp (177). 20