HP 6125XLG R2306-HP 6125XLG Blade Switch IP Multicast Configuration Guide - Page 123
Verifying the configuration, Troubleshooting MLD snooping, Layer 2 multicast forwarding cannot
View all HP 6125XLG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 123 highlights
[SwitchC-vlan100] mld-snooping enable [SwitchC-vlan100] quit # Configure Ten-GigabitEthernet 1/1/7 and Ten-GigabitEthernet 1/1/9 as static member ports for the IPv6 multicast group FF1E::101. [SwitchC] interface ten-gigabitethernet 1/1/7 [SwitchC-Ten-GigabitEthernet1/1/7] mld-snooping static-group ff1e::101 vlan 100 [SwitchC-Ten-GigabitEthernet1/1/7] quit [SwitchC] interface ten-gigabitethernet 1/1/9 [SwitchC-Ten-GigabitEthernet1/1/9] mld-snooping static-group ff1e::101 vlan 100 [SwitchC-Ten-GigabitEthernet1/1/9] quit Verifying the configuration # Display information about the static router ports in VLAN 100 on Switch A. [SwitchA] display mld-snooping static-router-port vlan 100 VLAN 100: Router slots (0 in total): Router ports (1 in total): XGE1/1/7 The output shows that Ten-GigabitEthernet 1/1/7 on Switch A has become a static router port. # Display information about the static MLD snooping forwarding entries in VLAN 100 on Switch C. [SwitchC] display mld-snooping static-group vlan 100 Total 1 entries). VLAN 100: Total 1 entries). (::, FF1E::101) Host slots (0 in total): Host ports (2 in total): XGE1/1/7 XGE1/1/9 The output shows that Ten-GigabitEthernet 1/1/7 and Ten-GigabitEthernet 1/1/9 on Switch C have become static member ports of the IPv6 multicast group FF1E::101. Troubleshooting MLD snooping Layer 2 multicast forwarding cannot function Symptom Layer 2 multicast forwarding cannot function through MLD snooping. Analysis MLD snooping is not enabled. Solution 1. Use the display mld-snooping command to display MLD snooping status. 116