HP CM3530 HP Color LaserJet CM3530 MFP Series - User Guide - Page 47
Initial Setup menu, Networking and I/O
UPC - 884420196501
View all HP CM3530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Initial Setup menu Administration > Initial Setup NOTE: Values shown with "(default)" are the factory-default values. Some menu items have no default. Networking and I/O Administration > Initial Setup > Networking and I/O Table 2-10 Networking and I/O Menu item Sub-menu item Values Description I/O Timeout Select a value in the range. The factory default setting is 15 seconds. I/O timeout refers to the elapsed time before a print job fails. If the stream of data that the product receives for a print job gets interrupted, this setting indicates how long the product will wait before it reports that the job has failed. Parallel Input NOTE: This item appears only if an EIO accessory is installed. High Speed Advanced Functions No Yes (default) Enabled (default) Disabled Use the High Speed setting to configure the speed that the parallel port uses to communicate with the host. Use the Advanced Functions setting to enable or disable bidirectional parallel communication. Embedded Jetdirect See Table 2-11 Jetdirect menus on page 33 for the list of options. EIO Jetdirect Table 2-11 Jetdirect menus Menu item Sub-menu item TCP/IP Enable Host Name IPV4 Settings Sub-menu item Config Method Values and Description Off: Disable the TCP/IP protocol. On (default): Enable the TCP/IP protocol. An alphanumeric string, up to 32 characters, used to identify the product. This name is listed on the HP Jetdirect configuration page. The default host name is NPIxxxxxx, where xxxxxx is the last six digits of the LAN hardware (MAC) address. Specifies the method that TCP/IPv4 parameters will be configured on the HP Jetdirect print server. Bootp: Use BootP (Bootstrap Protocol) for automatic configuration from a BootP server. DHCP: Use DHCP (Dynamic Host Configuration Protocol) for automatic configuration from a DHCPv4 server. If selected and a DHCP lease exists, DHCP Release and DHCP Renew menus are available to set DHCP lease options. Auto IP: Use automatic link-local IPv4 addressing. An address in the form 169.254.x.x is assigned automatically. ENWW Initial Setup menu 33