HP CM3530 Service Manual - Page 212
Post-service test, Print-quality test
UPC - 884420196501
View all HP CM3530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 212 highlights
Post-service test Perform the following test to verify that the repair or replacement was successful. NOTE: Your product might not appear exactly as the one shown in the photos in this chapter. Although some photos do not show the ADF/scanner unit, the procedures in this chapter are appropriate for your product. Print-quality test 1. Verify that you have completed the necessary reassembly steps. 2. Make sure that the tray contains clean, unmarked paper. 3. Attach the power cord and interface cable or interface cables, and then turn on the product. 4. Verify that the expected startup sounds occur. 5. Print a configuration page, and then verify that the expected printing sounds occur. 6. Print a demo page, and then verify that the print quality is as expected. 7. Send a print job from the host computer, and then verify that the output meets expectations. 8. If necessary, restore any customer-specified settings. 9. Clean the outside of the product with a damp cloth. Copy-quality test 1. Verify that you have completed the necessary reassembly steps. 2. Ensure that the input tray contains clean, unmarked paper. 3. Attach the power cord, and then turn on the product. 4. Verify that the expected start-up sounds occur. 5. Print a configuration page, and then verify that the expected printing sounds occur. 6. Place the configuration page in the ADF. 7. Print a copy job, and then verify the results. 8. Place the configuration page on the scanner glass. 9. Print a copy job, and then verify the results. 10. Clean the outside of the product with a damp cloth. 182 Chapter 6 Removal and replacement ENWW